Skip to content

HOT END

Jump to bottom
Denny Lia edited this page Jan 14, 2025 · 7 revisions

Hot End: Has the BLTouch probe mounted on the front of the cover. The cover is required to be on in order for the limit switches to be engage. If not in place Homing the head will bang against the end stops and grind (not good). You will also see that from the pictures that there is no room on the Left, Right or Behind for the BLTouch to mounted. The only place for the BLTouch is in the front.

BLTouchAdaptor2

LEFT and RIGHT Locations

HEAD_LEFT HEAD_RIGHT

FRONT Location

HEAD_FRONT

BACK: The head cover is held on by the two screws in the rear that mounts it to the base, that rides on the rails. The front of the cover clips neatly into the base not needing additional screws.

HEAD_SCREWS

Clone this wiki locally