weewx

This is a copy of the weewx.conf file I use with my PanTech PT-WH2900 aka WH65B which is a rebranded FineOff. The data is collected by a RTL SDR dongle with the WeeWX-SDR module

Added couple bits to do little maths under StdCalibrate for the Barometer BMP085 added to Raspberry Pi and added barometer correction as not sure if it changes based on temperature, and for radiation taken from Lux value.

[StdCalibrate]
    [[Corrections]]
        # For each type, an arbitrary calibration expression can be given.
        # It should be in the units defined in the StdConvert section.
        # Example:
        foo = foo + 0.2
        barometer = barometer + (outTemp-32) * 0.0091
        radiation = light * 0.007893

My alterations to [[Defaults]] so resaults are shown in metric system.

    [[Defaults]]

        # Which language to use for all reports. Not all skins support all languages.
        # You can override this for individual reports.
        lang = en

        # Which unit system to use for all reports. Choices are 'us', 'metric', or 'metricwx'.
        # You can override this for individual reports.
        unit_system = metricwx

        [[[Units]]]

            # Option "unit_system" above sets the general unit system, but overriding specific unit
            # groups is possible. These are popular choices. Uncomment and set as appropriate.
            # NB: The unit is always in the singular. I.e., 'mile_per_hour',
            # NOT 'miles_per_hour'
            [[[[Groups]]]]
                 group_altitude     = meter              # Options are 'foot' or 'meter'
                 group_pressure     = hPa                # Options are 'inHg', 'mmHg', 'mbar', or 'hPa'
                 group_rain         = mm                 # Options are 'inch', 'cm', or 'mm'
                 group_rainrate     = mm_per_hour        # Options are 'inch_per_hour', 'cm_per_hour', or 'mm_per_hour'
                 group_temperature  = degree_C           # Options are 'degree_C', 'degree_F', or 'degree_K'
                 group_speed        = km_per_hour        # Options are 'mile_per_hour', 'km_per_hour', 'knot', 'meter_per_second', or 'beaufort' 
                # The following line is used to keep the above lines indented properly.
                # It can be ignored.
                unused = unused

            # Uncommenting the following section frequently results in more
            # attractive formatting of times and dates, but may not work in
            # your locale.
            [[[[TimeFormats]]]]
                 day        = %H:%M
                 week       = %H:%M on %A
                 month      = %d-%b-%Y %H:%M
                 year       = %d-%b-%Y %H:%M
                 rainyear   = %d-%b-%Y %H:%M
                 current    = %d-%b-%Y %H:%M
                 ephem_day  = %H:%M
                 ephem_year = %d-%b-%Y %H:%M
                # The following line is used to keep the above lines indented properly.
                # It can be ignored.
                unused = unused

Added group_speed to [[[[Groups]]]] as it was not added in the default config

                 group_speed        = km_per_hour        # Options are 'mile_per_hour', 'km_per_hour', 'knot', 'meter_per_second', or 'beaufort'.

Work in progress

Get RSSI/SNR/Noise data added to Sensor Status on the web page